The Hygge sensor will ONLY work where you have cellular service from AT&T. You must be able to make and receive calls from the location the sensor will be placed. The sensor should only be used indoors. Outdoor use is not recommended and may damage system components. The following locations are recommended for use:
In attics
In basements
Storage facilities
RVs
Blue Light
Blinking blue light indicates looking for a cellular signal, once signal is found it will turn solid.
If sensor is still blinking blue light after ~120 seconds there is no cellular service. Move sensor to an area with cellular service.
Blue light will turn off after 1 hour and then blink 1x per minute when readings are taken.
Green Light
A flashing green light means the cellular modem is trying to find the nearest tower, once it finds one it will turn solid during cellular communication.
Hanging the Monitor
The monitor comes with a plastic hanger with two holes. Attach the hanger flat against the wall with the curve side up using nails or the two pieces of double-sided adhesive based on your wall surface* at least 4ft off the ground. Align the back hole of the monitor to the top end of the hanger to attach it. *Do not use adhesive on wallpaper, brick, textured walls, or rough surfaces.
Leak Detection
If you purchased a Hygge Sensor with leak detection cable you will have a 6' black leak detection cable that is connected to a 3' leak detection rope. Connect the black cable to the to the Hygge sensor then place the leak detection rope flat on the ground.
Battery Management
CR123A Lithium Batteries are used in the Hygge sensor. New batteries are installed when the sensor is shipped and will provide roughly 6 days of total power to the sensor in the event of many shorter outages or a single longer outage.
When on battery power you will see the battery indicator image in the top right of the device page showing how much battery life is remaining.
System Information
-4 to 120 °F(accuracy +-1 °)
Humidity sensor accuracy +- 3%
Replaceable backup battery good for 5+ days
3.26x1.22x3.18 inches
6' Leak Detection cable(optional)
3' Leak Detection rope(optional)
FCC-ID: XMR2020BG95M1
Device Issues
Should you have issues with your Hygge sensor please contact support at contact@hyggeapps.com. Please include your device serial number which can be found at the bottom of your device page
